Filter
Top Products
20
The “GPI CONTROL” item is used to set enable/disable of all GPI functions, and assigns functions to each of the
GPI terminal pins (J page 23).
The underlined values are factory preset setting values.
Note:
Please be aware that the following can not be performed.
• “SD ASPECT” operation when input signal is HD or PC
• “SCAN” operation when the input signal is PC
• “GAMMA SELECT” operation when the input signal is PC
• “RGB SYNC” operation when anything other than “RGB-VIDEO” is selected in “YP
BPR/RGB” in the “INPUT
SELECT” menu
• “MONO” operation when input signal is PC
GPI
Sub menu Settings Explanation
GPI CONTROL
<DISENABLE>
<ENABLE>
GPI functions enable/disenable settings
GPI1–GPI8
<UNDEF>
<MARKER1 ON/OFF>
<MARKER2 ON/OFF>
<MARKER BACKHALF>
<MARKER BACKBLACK >
<CENTER MARKER>
<INPUT SEL. VIDEO>
<INPUT SEL. Y/C>
<INPUT SEL. SDI1>
<INPUT SEL. SDI2>
<INPUT SEL. YP
BPR/RGB>
<SD ASPECT>
<SCAN>
<R-TALLY>
<G-TALLY>
<MONO>
<GAMMA SELECT>
<RGB SYNC>
Used to set the GPI control terminal pin assign.
You can set the same items for each terminal
(refer to page 23 for details).
Main Menu (continued)