Filter
Top Products
8
E
Using the Drive
For details on how to insert and remove the drive, refer to “Multimedia Pocket” in the
Reference Manual included with your computer.
Inserting/Removing the Drive
Preparations
Confi rm that [Transfer Mode] is set to [DMA if available] in [start] - [Control Panel] -
[Performance and Maintenance] - [System] - [Hardware] - [Device Manager] - [IDE ATA/
ATAPI controllers] - [Primary IDE Channel] - [Advanced Settings] - [Device 0]. Perform
this setting if it has not yet been made.
1
Turn on the computer.
2
Slide the latch (A) and open the cov-
er.
3
Press the eject button (B) and slowly
pull out the tray.
4
Insert/Remove the disc.
To insert
Set the disc with the label side up and press the
center of the disc until it clicks in place.
To remove
Press on the center spindle (C) and carefully lift up
the edge of the disc.
5
Close the tray.
Do not press the eject button.
Setting a Disc