Panasonic CZ-RWSK1U Universal Remote User Manual


 
16
11. ADDRESSES
In both multi and single unit installations, when more than one indoor unit is installed in the same
room with a compatible remote controller, addresses can be set up to avoid crosstalk.
By setting the address switches on the receivers and matching them with the number of addresses on
the remote controller, up to six indoor units can be controlled separately with the remote controller.
(When using units in a fl exible combination or operating multiple units simultaneously, as they are
operated at the same time, they cannot be controlled individually.)
There are separate address settings, receiver addresses for the receivers*
1
and transmitter addresses
for the remote controller.
For more information, please contact the dealer where the product was purchased.
The setting procedure is different for CZ-RWSY1U and Indoor Unit (CZ-RWSK1U). (See Page 18)
These settings are saved in nonvolatile memory in the remote controller, so even when its batteries
are changed, the settings do not have to be made again.
*
1
CZ-RWST1U is of receivers (Inside the indoor unit); CZ-RWSU2U is of an operation panel. (Inside
the indoor unit)
Checking Addresses
When you press on the remote controller, its current address is shown in the display. If this
address corresponds to the address of a receiver*
2
, the buzzer sounds. (If it is on ALL, the buzzer will
always sound.)
If it is on ALL, it can be operated regardless of receiver addresses. Point the remote controller at the
receiver you wish to operate and transmit.
*
2
CZ-RWSU2U is a receiver (Indoor unit)
Matching up Addresses
Setting Remote Control Addresses
1. If you press
and at the same time, “ ” will blink.
2. While holding
down, every time you press , it cycles from ALLÆ1Æ2Æ3…
6ÆALL.
Set it to the receiver address switch of the indoor unit you wish to operate.
3. When you release , the address that was displayed is set.
When you do this, if it corresponds to the receiver’s address setting, the buzzer sounds.