Panasonic CZ-RWST1U Universal Remote User Manual


 
11
6. TIMER OPERATION
When setting the timer, make sure the current time on the remote controller is accurate.
The timer’s clock can only be set when the display of the remote controller is ON.
After setting the timer, put the remote controller in a place where its signal will reach the receiver of
the indoor unit. (When the time set for the timer is reached, a signal is sent from the remote
controller to Start/Stop the unit.)
Using the Timer
1. Press either
/
of the
or
, and while the time is
being displayed, if you press
/
again, a scheduled time can
be set.
The time last set on the timer is displayed.
“--:--“ indicates time to change the batteries.
2. Press either
/
of the
or and set the timer to the
desired time.
Every time you press
/
, the time changes in 10 minute increments.
If you press and hold the button, the time changes quickly.
3. After setting the timer, if you press , the time you set
changes to a steady display, indicating settings are complete.
After the timer setting is displayed for three seconds, the display reverts to
the current time.
1, 23