Panasonic DVD-RA61 DVD Player User Manual


 
4
RQT6043
Getting started
AC mains lead . . . 1
[For\the\United\Kingdom]
(RJA0053-2X)
[For\others]
(RJA0019-2X)
Accessories
Please check and identify the supplied accessories. Use numbers indicated in parentheses when asking for replacement parts.
Remote
control . . . . . . . . . 1
(N2QAJB000018)
Batteries . . . . . . . 2
for remote control
[For\Australia\and\N.Z.]
(RJA0035-1X)
Audio/video
cable. . . . . . . . . . . 1
(VJA0788-D)
Note
The included AC mains lead is for use with this unit only. Do not use it with other equipment.
Connection to a television
Although the audio on most DVDs is designed to be played through six speakers and this units factory settings assume this setup, the following describes
connections that allow you to enjoy sound through your televisions speakers. To get the full benefit from the powerful 5.1-channel audio found on DVDs,
you should connect an amplifier and six speakers ( page 16).
Before connection
Disconnect the AC mains lead.
Refer to the televisions operating instructions.
AUDIO
IN
L
R
VIDEO
IN
VCR
SCART
IN
S VIDEO
COMPONENT
VIDEO OUT
Y
P
B
P
R
COMPONENT
VIDEO IN
Y
P
B
P
R
DIGITAL AUDIO OUT
(
PCM/BITSTREAM
)
CENTER
AUDIO OUT
SUB-
WOOFER
R
R
FRONT
R
SURROUND
VIDEO
OUT
S VIDEO
OUT
AC IN
~
OPTICAL
SURROUND
L
FRONT
L
L
AV1
AV2
2ch5.1ch
Audio/video cable (included)
AC mains lead (included)
FOR UNITED KING-
DOM ONLY
READ THE CAUTION
FOR THE AC MAINS
LEAD ON PAGE 3 BE-
FORE CONNECTION.
AV2
AV1
AV2
AV1
TV
VCR
SCART terminal
To improve picture quality, you can change the video signal output from
the AV1 terminal from Video to either S-Video or RGB to suit the type
of television you are using ( page 18, VideoAV1 Output).
You can also connect other equipment to AV2.
red white yellow
Connection to AUDIO IN
also necessary (see left)
[For\Australia.\N.Z.\and\Asia]
Connection to AUDIO IN
also necessary (see left)
21-pin SCART
cable
(not included)
This unit
Video
cassette
recorder
SCART terminal
of television
Satellite receiver
or decoder
S VIDEO OUT terminal
The S-video terminal achieves a more vivid picture than the VIDEO OUT
terminal by separating the chrominance (C) and luminance (Y) signals.
(Actual results depend on the television.)
COMPONENT VIDEO OUT terminal
Connection using these terminals outputs the color difference signals (PB/
P
R) and luminance signal (Y) separately in order to achieve high fidelity in
reproducing colors.
The description of the component video input terminals depends on the
television or monitor (e.g. Y/P
B/PR, Y/B-Y/R-Y, Y/CB/CR).
Connect to terminals of the same color.
Connect Your Unit Directly To Your Television.
Do not connect the unit through your video cassette recorder when
setting up your home entertainment system, because the picture may
not be played correctly due to the copy guard.
S video cable
(not included)
red white yellow
Video cable
(not included)
For the United Kingdom,
Continental Europe and Russia
(The illustration shows the model for the United Kingdom, Continental Europe and Russia.)
To household
mains socket