Filter
Top Products
72
Function menus
F1
SHIFT
F2 F3 F4 F5 F6
Registered item name
Registered value
Selection marker
<50P IN/OUT ASSIGN>
Pins in which functions can be registered
IN pins: Pins 6 to 20, 22, 23, 25
OUT pins: Pin 21, 24, pins 32 to 46, 48
All other pins are reserved and cannot be changed.
Using the front panel controls and on-screen menus,
functions are registered into the input pins of the
parallel remote (50PIN) connector and the statuses
are registered into its output pins.
When (50P IN) or (50P OT) is pressed while
the button is held down on the <MENU SHIFT>
menu, the function menu shown below appears, and
functions can be registered or deleted.
F
F6F5
Items which can be registered in the input and
output pins
Items identical to the setup menu items can be
registered in both the input and output pins. In
addition, there are a set of special items can be also
registered in the input pins and another set for the
output pins.
<Note>
System menu and submenu items cannot be
registered.
IN pins OUT pins
1 REC
21
Range of pins to which any
items can be assigned
24
26 <Power>
27 REC
28 PLAY
29 FF
30 REW
31 STOP
32
Range of pins to which
any items can be
assigned
:
l
;
46
48
47 <GND>
49 <GND>
50 <GND>
2 PLAY
3FF
4 REW
5 STOP
6
Range of pins to which
any items can be
assigned
:
l
;
20
22
23
25
Registration in input pins
Setup menu list
Special IN menu list
<No display>
<No display>
Special OUT menu list
Registration in output pins
100
000
Item no.
200
300
400
500
600
700
B00
C00
Registered item names
Setup menu items and 50PIN special menu items can
be registered in the parallel remote connector pins,
and the names of these menu items are displayed.
Registered values
One setting for the registered menu item is displayed
in each of the pins.
When active signals are input to the IN pins in which
the setup menu items mentioned above have been
registered, the settings for the registered menu items
take effect inside the VTR.
When the settings for the registered menu items tally
with the registered values, active signals are output
from the registered OUT pins.
Item selection cursor
Item number
Item number
Category
Setting
Setting number
Item name