Filter
Top Products
31
RQT8237
31
FM transmitter
You can enjoy listening to discs or SD cards through your FM radio channel (e.g. car stereo) by
transmitting audio signals from this unit.
p
The FM transmitter can also be used with normal FM radio-equipped devices.
To turn off the FM transmitter : Press [FM-TM] and then [
] to select “OFF”.
To exit the screen: Press [FM-TM].
Preparation: Unplug headphones and audio/video cable from the unit.
p
When connected, the FM transmitter will not work.
When this has not been successful
p
If you experience noise or distortion of audio, move the radio antenna closer to the unit. Or select
“MONO” from the menu screen using [
]. If the audio quality still does not improve, then
change the radio frequency (➜ above, “When this has not been successful”).
1
Play the disc or SD card. (➜ page 12 or page 14)
2
Press to display
the menu.
FM TRANSMITTER
STEREO
88.3 MHz
MONO
ON OFF
If the menu is not displayed, check the “Preparation” steps listed above.
p
No sound is heard from this unit. For the volume on this unit, set the on screen volume
level using the following indications.
– DVD movies: the far right side
– Others:near the middle
The above settings are to be used only as a rough estimate. Depending on the recording
conditions of the disc or card, the actual appropriate volume level may differ. If the volume is
inappropriate in step 5, readjust the volume.
3
ENTER
Press [
] to select “ON”.
The orange lamp next to the [FM-TM] button lights up.
4
Tune the radio to the 88.3 MHz FM frequency.
When another FM broadcast is heard.
(➜ see below, “When this has not been successful”)
5
Adjust the volume using the radio.
1
Press to display the menu.
2
Press
[
]
to select the frequency
(“88.3 MHz”) (factory preset) .
Press [] , to select a frequency between
88.3 MHz and 107.7 MHz which is not being
used by any broadcasting stations.
p
The frequency can be set in 0.1 MHz increments.
ENTER
Tune the FM radio into the fre
q
uenc
y
selected in ste
p
2.
3
Enjoying in a car