Filter
Top Products
8
Connect the Removed Hard Disk Drive with the PC
Connect the removed hard disk with the PC in which this software is installed as follows.
Step 1
Remove the removal hard disk drive from the WJ-ND200.
Note:
Refer to the installation guide or the operating instructions (PDF) of the WJ-ND200 for how to remove the remov-
able hard disk drive.
Step 2
Connect the removed hard disk drive and the PC in which this software is installed using an optional interface cable.
Note:
Contact your dealer about the interface cable to be used to connect the removable hard disk drive and the PC.
Step 3
Check if the connected hard disk drive is displayed in "My Computer".
Important:
The connected hard disk drive will be displayed as "Local Disk (*:)".
("*" varies depending on the system configuration of the PC.)
Do not perform the following operations on this local drive.
Otherwise, this hard disk drive may become inoperable on both the WJ-ND200 and the viewer software.
• Deletion of folders and files
• Move of directories of folders and files
• Edit of folders and files (contents, attributes, etc.)
• Defragmentation
• Formatting