Filter
Top Products
35
VCR
Operation
P DT START STOP CH SPD
1 10 9:00a12:00p 08 SP
2day 11:00a11:30a125 SP
3 12 8:00p 9:30p L1 SLP
4 -- --:-- --:-- -- --
CANCEL:ADD/DLT
SELECT: SET:SET
EXIT :PROG
P DT START STOP CH SPD
1 -- --:-- --:-- -- --
2day 11:00a11:30a125 SP
3 12 8:00p 9:30p L1 SLP
4----:----:-- -- --
SELECT: SET:SET
END :PROG
Hold down STOP for a few seconds to
cancel the Timer Recording.
• Any future daily or weekly recordings will be
performed as programmed.
Cancel a Timer Re cord ing:
(Recording is in progress)
5 Press PROG twice to exit this mode.
To Replace program...
To Clear program...
4 Press ▲▼ to select the desired
program.
a. Press SET to display.
b. Press ▲▼ to select and press SET
or ◄► to set new program
contents.
c. Press PROG.
Press ADD/DLT.
• 2 minutes before Timer recording is performed,
“PLEASE PREPARE FOR TIMER REC” appears
and/or the PROG TIMER Indicator flashes. Be
sure a cassette with record tab is loaded and the
unit is in Stop mode.
• If the start times of two programs overlap, the
lower numbered program will have priority.
• If the start time for a Timer Recording comes up
during a normal recording or One Touch
Recording (page 31), the Timer Recording will
not be performed.
• If there is a power interruption of more than one
minute, the recording may not be performed or
continued.
• If “INCOMPLETE” appears after all items have
been set, check all entries and make necessary
corrections.
1 Press PROG to display SET
PROGRAM screen.
2 Press ▲▼ to select “TIMER
PROGRAMMING.”
3 Press SET to display screen.
SET PROGRAM
TIMER PROGRAMMING
ON TIMER
SLEEP TIMER: 0
SELECT: SET:SET
END :PROG
Review, Replace or
Clear Program Con tents :
(Recording is not in progress)
Notes
P DT START STOP CH SPD
1 10 9:00a12:00p 08 SP
2day 11:00a11:30a125 SP
3 12 8:00p 9:30p L1 SLP
4----:----:-- -- --
CANCEL:ADD/DLT
SELECT: SET:SET
END :PROG