Panasonic PT-52LCX15 Projection Television User Manual


 
7
Getting Start ed
Requires two AA batteries (supplied).
2. Install the batteries as shown in the battery
compartment.
(Polarity + or - must match the markings in the
compartment).
Two AA size
Remote Control Battery Installation
CAUTION
1. While pressing in on the catch, open cover in
direction of arrow.
3. Press cover in direction of arrow until it snaps
shut.
Incorrect battery installation can cause the batteries to
leak, leading to personal injury and/or damage to the
remote control.
Observe the following precautions:
1. Batteries should always be replaced as a pair.
Always use new batteries when replacing the old
set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon”
with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble,
heat or burn used batteries.
5. Battery replacement is necessary when the remote
control acts sporadically or stops operating the
Projection Display set.
Helpful Hints:
(1) For frequent remote control users, replace old
batteries with Alkaline batteries for longer battery
life.
(2) Whenever you remove the batteries, you may
need to reset the remote control infrared
codes. We rec om mend that you record the code
on pages 58-59, prior to setting up the remote.
Reset All Memory Functions
Use when moving unit to a new location, or First Time
Setup needs to be redone.
Press the VOL- button on the unit
and OK button on the Remote
control at the same time for more
than 3 seconds. When reset is done,
power shuts off automatically.
CH
CH
VOL VOL
OK