RS-232C Control Specifications PT-AE2000
As of October 2007 < 4 >
Parameter format
Parameter format Size (Byte) Difinition
<off_on>
<input signal>
<power condition>
<off_timer>
<x>
1
3
3
1
1
0 = off, 1 = on
VID = video, SVD = S-video, RG1 = computer, CP1 = component 1,
CP2 = component 2, HD1 = HDMI 1, HD2 = HDMI 2, HD3 = HDMI 3
000 = power on (standby mode on), 001 = power off (standby mode off)
0 = off, 1 = 60 min, 2 = 90 min, 3 = 120 min, 4 = 150 min, 5 = 180 min,
6 = 210 min, 7 = 240 min
0 = off, 1 = full scan (Y), 2 = full scan (R), 3 = full scan (G), 4 = full scan (B),
5 = single line (Y), 6 = single line (R), 7 = single line (G), 8 = single line (B)
Command example
To set the volume to +30, send the command as shown below.
STX AVL : 30 ETX
Start Command Parameter End
NOTE: If a wrong command is received, the projector will send an ER401 command to the computer.
NOTE: When sending commands without parameters, a colon (:) is not necessary.