Filter
Top Products
31
Troubleshooting
Before asking for service
Check the following before asking for service.
Symptom
Computer cannot
recognise the SD
memory card
Writing is not
possible
Video signals
from the computer
cannot be pro-
jected.
Check the following
BHas the PC card adapter been securely inserted
into the PC card slot of the computer?
BHas the SD memory card been securely inserted into
the SD memory card slot of the PC card adapter?
BHas the driver been installed correctly?
BAre insufficient computer system resources avail-
able? (Refer to the Windows online help.)
BIs the write-protect switch on the SD memory card
set to the LOCK position?
BIf using a notebook computer, has the external
output been configured properly? (It may be pos-
sible to toggle the external output settings by press-
ing the Fn key and the F3 key at the same time. This
depends on the type of computer you are using.
Check the computer documentation for details.)
NO FILE
CARD FULL
WRITE
PROTECTED
NON STANDARD
CARD
COPY GUARD
SIGNAL
LAST FILE
NO CARD
ERROR
There are no image files that can be displayed by the
projector on the SD memory card.
There is no free space on the SD memory card.
The write-protect switch on the SD memory card is set
to the LOCK position. Capturing, deleting and moving
files is not possible.
A non-standard card has been inserted.
The video signal being input includes a copy guard
signal. Capturing is not possible with such signals.
The directory contains only one file, and this file cannot
be deleted.
No SD memory card has been inserted.
An error has occurred with some operation. If the error
cannot be reset by pressing the input select (INPUT,
RGB, VIDEO) button, turn off the projector power by
following the procedure given under "Turning off the
power" in the PT-L702E or PT-L701E Operating In-
structions, and then turn the power back on again.