Filter
Top Products
Getting Started
Setting up
ENGLISH - 17
You can use the projector with any of the following 4 projection methods. To set the desired method in the projector,
See “INSTALLATION” on page 37..
You can adjust the projection angle in the vertical direction by pressing the Font leg adjuster buttons.
See “Positioning the image” on page 24.
Projection method
J Setting on a desk/floor and
projecting from front
J Setting on a desk/floor and
projecting from rear
INSTALLATION: FRONT/DESK INSTALLATION: REAR/DESK
J Mounting in the ceiling and
projecting from front
J Mounting in the ceiling and
projecting from rear
INSTALLATION: FRONT/CEILING INSTALLATION: REAR/CEILING
NOTE:
• A translucent screen is required for rear projection.
• When mounting the projector in the ceiling, the optional ceiling mount bracket (ET-PKB50) is required.
Front adjustable legs and throwing angle
NOTE:
• Heated air comes out of the Air exhaust port. Be careful of this when adjusting the Font adjustable legs.
• If keystone distortion occurs, see “KEYSTONE” on page 34.