Filter
Top Products
30
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
On-Screen Display (OSD)
Warning and Instruction Displays
These displays will alert you to a missed
operation or provide further instructions.
Press DISPLAY
to display or remove the overlay.
Whenever a blank section of a tape comes
up in Play mode, or when the selected
channel has no broadcast signal with the
Weak Signal Display set to “OFF” (see
page 27), the screen will turn solid blue.
When a function button is pressed (PLAY,
FF, etc.) or you change channels, the unit
mode or channel number will be displayed.
(Some station names may also appear if
Channel Caption is set. See page 28.)
0
8
A
BC
REC
1
2
:
0
0
P
M
0
:
25
ABC
-
0
:
1
2
:
3
4
SP
Function Status
Current Time
Rec Time
Remaining
(OTR mode only,
see page 12.)
Counter
Tape Speed
Channel Caption
(See page 28.)
VCR Status & Clock Display
Blue Screen Display
Channel & Function Display
32
OSD
PLEASE SET CLOCK BEFORE
PROGRAMMING
CHECK CASSETTE RECORD TAB
TO CANCEL TIMER REC HOLD DOWN
STOP KEY FOR APPROX 3 SEC
NO CASSETTE
PLEASE INSERT A CASSETTE
PLEASE PREPARE FOR TIMER REC
VIDEO HEADS MAY NEED CLEANING
PLEASE INSERT HEAD CLEANING
CASSETTE OR REFER TO MANUAL
END: PLAY KEY
VCR LOCK ACTIVATED
Caution
• If you attempt to set or review a Timer Recording,
or set the On-Timer and the Clock is not set...
• If you press REC, and a cassette is inserted with
no record tab...
• If you press STOP during a Timer Recording...
• If you press PLAY, FF, REW, or REC without a
cassette inserted...
• If the unit is not in Stop mode or a cassette with
record tab is not inserted two minutes before a
Timer Recording is about to begin...
• If head cleaning becomes necessary while playing
back a tape...
• If you press a function button other than STOP/EJECT
or POWER while the unit is in VCR Lock mode...
Page
8 - 11
3, 12
23
12
22, 23
4
27