Panasonic SC-HC2818EB DVD Player User Manual


 
10
RQT9731
Preparation
Turn the unit on.
A station previously stored is overwritten when another
station is stored in the same channel preset.
1 Press [PLAY MENU] to select “A.PRESET”.
2 Press [3, 4] to select “LOWEST” or “CURRENT”
and then press [OK].
LOWEST:
CURRENT:
To begin auto preset with the current frequency.*
* To change the frequency, refer to “Manual tuning and
presetting”.
The tuner starts to preset all the stations it can
receive into the channels in ascending order.
Preparation
1 Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2 Press [3, 4] to select “PRESET” and then press
[OK].
Press [:/6] or [5/9] to select the channel.
Manual tuning and presetting
Select a radio broadcast.
1 Press [PLAY MENU] repeatedly to select
“TUNEMODE”.
2 Press [3, 4] to select “MANUAL” and then press
[OK].
3 Press [:/6] or [5/9] to tune to the
required station.
To start automatic tuning, press and hold [:/6],
[5/9] until the frequency starts scrolling. Tuning
stops when a station is found.
To preset the channel
4 While listening to the radio broadcast
Press [OK].
5 Press [3, 4] to select the channel and then press
[OK].
To improve FM sound quality
1 While receiving FM broadcasts, press
[PLAY MENU] repeatedly to select “FM MODE”.
2 Press [3, 4] to select “MONO” and then press
[OK].
This setting can be preset and memorised. To do so,
continue to step 4 of “Manual tuning and presetting”.
Select “STEREO” in step 2 to return to stereo broadcasts.
“MONO” is cancelled if the frequency is changed.
Press [DISPLAY] to display the text data.
Each time you press the button:
“STEREO” is displayed when this unit tunes to a stereo
broadcast.
The unit can display the text data transmitted by the radio
data system (RDS) available in some areas. (RDS displays
may not be available if reception is poor.)
Listening to FM radio
You can preset up to 30 channels.
Make sure that the antenna is connected. (l 5)
Press [RADIO] to select “FM”.
Presetting stations automatically
To begin auto preset with the lowest frequency
(FM 87.50).
Listening to a preset channel
If “MONO” is selected, regardless of the type of signal this
unit is receiving, “FM MONO” is displayed. (l below)
To display the current FM signal status
[SC-HC28DB]
While receiving FM broadcast, press [DISPLAY].
[SC-HC18]
While receiving FM broadcast, press [PLAY MENU] to
display “FM STATUS” and then press [OK].
“FM ST”: The FM signal is in stereo.
“FM”: The FM signal is in monaural.
“FM” is also displayed even if this unit is not tuned to a
station.
[SC-HC18] To display RDS text data
“PS”: Programme service
“PTY”: Programme type
“FREQ”: Frequency display
SC-HC28_18_EB~RQT9731-B.book 10 ページ 2013年1月3日 木曜日 午後8時25分