Filter
Top Products
48
1
678
3
9
45
10
1514131211
2
Technical Information (Continued)
Input signal that can be displayed
* Mark: Applicable input signal for Component (Y, PB, PR), HDMI and PC
horizontal frequency (kHz) vertical frequency (Hz) COMPONENT HDMI PC
525 (480) / 60i 15.73 59.94
**
525 (480) /60p 31.47 59.94
**
750 (720) /60p 45.00 59.94
**
1,125 (1,080) /60i 33.75 59.94
**
640 × 400 @70 31.47 70.08
*
640 × 480 @60 31.47 59.94
*
Macintosh13” (640 × 480) 35.00 66.67
*
640 × 480 @75 37.50 75.00
*
852 × 480 @60 31.47 59.94
*
800 × 600 @60 37.88 60.32
*
800 × 600 @75 46.88 75.00
*
800 × 600 @85 53.67 85.08
*
Macintosh16” (832 × 624) 49.73 74.55
*
1,024 × 768 @60 48.36 60.00
*
1,024 × 768 @70 56.48 70.07
*
1,024 × 768 @75 60.02 75.03
*
1,024 × 768 @85 68.68 85.00
*
Macintosh 21” (1,152 × 870) 68.68 75.06
*
1,280 × 768 @60 47.70 60.00
*
1,280 × 1,024 @60 63.98 60.02
*
1,366 × 768 @60 48.36 60.00
*
Note
Signals other than above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.
PC Input Terminals Connection
Computer signals which can be input are those with a horizontal scanning frequency of 15 to 110 kHz and vertical scanning frequency
of 48 to 120 Hz. (However, the image will not be displayed properly if the signals exceed 1,200 lines.)
Some PC models cannot be connected to the set.
There is no need to use an adapter for computers with IBM PC/AT compatible D-sub 15P terminal.
The maximum resolution: 1,280 × 1,024
If the display resolution exceeds these maximums, it may not be possible to show fine detail with sufficient clarity.
Signal Names for D-sub 15P Connector
Pin No.
Signal Name
Pin No.
Signal Name
Pin No.
Signal Name
R GND (Ground) NC (not connected)
G GND (Ground) NC
B GND (Ground) HD/SYNC
NC (not connected) NC (not connected) VD
GND (Ground) GND (Ground) NC
Pin Layout for PC Input Terminal
H size
Aspect Ratio: 4:3
Size 1 Size 2
The width will be decreased on both sides to
reduce noise.
Aspect Ratio: FULL/JUST(H-FILL/ZOOM)
Size 1 Size 2
The width will be increased on both sides to
reduce noise.
See pages 26-27 for more information