Filter
Top Products
10
AC Power Cord Connection
This LCD TV uses nominal input voltages of 110-127V AC.
It is designed to work with single-phase power systems. To
reduce risk of electrical shock, do not plug into any other type
of power system. Consult your authorized dealer or service
station if you are not sure the type of power being supplied.
Connect the LCD TV with all peripheral equipment before
turning the LCD TV on.
Caution
•
For safety, unplug AC power cord when the LCD TV is not
in use.
Antenna or Cable Connection
Cable used for connection (This Outdoor Aerial cable is not
supplied with this LCD TV.)
•
Aerial Cable
ST3
AV IN
PC AUDIO
via AUDIO IN
COMPONENT
Note:
•
ATSC is not available except in U.S.A., Canada, and/or
Mexico.
•
For all aerial circuit problems, please consult your local
dealer.
Remote Control Batteries Installation
1. Remove the battery compartment cover.
2. Insert two size AAA batteries (1.5V) according to “+” and
“-” polarity markings inside the battery compartment.
3. Close the battery compartment cover.
Caution
To insure safe operation, please observe the following
precautions:
•
Replace two batteries at the same time.
•
Do not use a new battery with a used battery.
•
Avoid contacting with water or liquid.
•
Do not expose the Remote Control or Batteries to moisture,
or heat such as sunshine, fire or the like.
•
Do not drop the Remote Control.
•
If a battery has leaked on the Remote Control, carefully wipe
case clean and install new batteries.
•
Risk of explosion if battery is replaced by an incorrect type.
•
Dispose of used batteries according to the instructions.
•
Remote control contains AAA battery and must be kept out
of reach of small children to avoid accidental ingestion.