Filter
Top Products
15
First Time Setup
or
Turn the TV on with the POWER button
or
(Remote)(TV)
Setup the following items
●
Select your language
●
Select your viewing mode (Be sure to select “ Home Use”)
If you select “ Store Demonstration” by mistake, confirmation screen
will be displayed.
To display the “Set viewing mode” screen again and select “Home
Use”, perform “Reset to defaults” in the “Setup” menu.
●
ANT/Cable setup
Select signal type (Over-the-Air/Cable service).
Select Auto Program and start scanning.
Scanning starts.
Note
If at the end of the scanning no channels are found, then check:
1. Antenna’s position – or
2. Availability of Cable service
Cable, Satellite or Fiber services with a box are typically connected to
the TV’s A/V inputs, preferably HDMI, for best HD picture. In such a
case, the channel scanning is not needed (set “ANT in” to “Cable”).
Complete First time setup
Completion screen is displayed.
You can repeat the First time setup
• Press MENU
--
> Setup
--
> Reset to defaults
To watch TV via a Cable box, Satellite receiver, or any other source
(DVD, DVR, gaming device, etc.), press the INPUT button and select
the appropriate input.
The setup screen will be displayed only when the TV is turned on for the first time and after
the power cord is inserted into a wall outlet.
Getting started
First Time Setup
Identifying Controls