Panasonic TC-P50S2 Flat Panel Television User Manual


 
46
Technical Information (Continued)
H size
Aspect Ratio: 4:3
Size 1 Size 2
The width will be decreased on both sides to
reduce noise.
Aspect Ratio: FULL/JUST(H-FILL/ZOOM)
Size 1 Size 2
The width will be increased on both sides to
reduce noise.
See page 26 for more information
4:3 side bars
Do not display a picture in 4:3 mode for an extended period, as this can cause
“Image retention” to remain on either or both sides of the display field.
To reduce the risk of such “Image retention”, change the brightness of the side
bars.
See page 27 for more information
The side bar may flash (alternate black/white) depending on the picture.
Using Cinema mode will reduce such flashing (p. 45).
Side Bar
4:3
Screen
Display
Image retention
Scrolling bar
Scrolling bar: To prevent “Image retention”, scrolls white vertical bar from left to right on a black screen.
Press any key except the POWER key to return to previous screen.
You will return to the previous screen if no key operation has been performed for 15 minutes.
See page 27 for more information
[Scrolling bar]
Input signals that can be displayed
* Mark: Applicable input signal for Component (Y, PB, PR) and HDMI
horizontal
frequency (kHz)
vertical
frequency (Hz)
COMPONENT HDMI
525 (480)/60i
15.73 59.94
**
525 (480)/60p
31.47 59.94
**
750 (720)/60p
45.00 59.94
**
1,125 (1,080)/60i
33.75 59.94
**
1,125 (1,080)/60p
67.43 59.94
*
1,125 (1,080)/60p
67.50 60.00
*
1,125 (1,080)/24p
26.97 23.98
*
1,125 (1,080)/24p
27.00 24.00
*
Note
Signals other than those shown above may not be displayed properly.
The above signals are reformatted for optimal viewing on your display.