Filter
Top Products
9
Accessories
Assembly screws
A
XYN4+F10FNK (Black)
size (M4 x 10)
(for 50” (5), for 55” (1))
B
XYN5+F16FN (silver)
size (M5 x 16)
(for 50” (7), for 55” (12))
Bracket (1)
TBL5ZA3254 (for 50”)
TBL5ZA3200 (for 55”)
Neck (1)
TXFBL5Z0083 (for 50”)
TXFBL5Z0086 (for 55”)
Cover (1)
TXFBL5Z0091 (for 50”)
TXFBL5Z0056 (for 55”)
Cover is in the same bag
with Owner’s Manual
Base (1)
TBL5ZX0313 (for 50”)
TBL5ZX0328 (for 55”)
Attaching the pedestal to TV
■
Assembling the pedestal
Insert the protrusion of the Neck
into the Base firmly.
Neck
Protrusion of the
Neck (bottom)
Front
Turn the stand over and fix stand neck
securely with assembly screws.
(for 50”: 3 screws, for 55”: 4 screws
)
•
Do not hold the neck when turning over the stand.
B
x 3 pcs. (for 50”)
B
x 4 pcs. (for 55”)
Front
Back of Stand
Hole for
screw
[TC-P50GT50]
[TC-P55GT50]
Attach the Bracket to the protrusion of Neck.
Make sure that the bracket is anchored
before fixing the screws.
Fix securely with assembly screws. (4 screws)
B
x 4 pcs.
Bracket
Protrusion of Neck (top)
Attach the cover and fix securely with
assembly screw.
A
x 1 pcs.
Cover
■
Set-up
Tighten assembly screws (total 4 screws) loosely at first,
then tighten them firmly to fix securely.
B
A
x 4 pcs. (for 50”)
x 4 pcs. (for 55”)
Arrow
mark
(Image)
Rear side
Hole for pedestal
installation
Bracket
Base
Work on a flat surface
Removing the pedestal from the TV
Be sure to remove the pedestal in the following way when
using the wall hanging bracket or repacking the TV.
Remove the assembly screws (for 50”)/ (for 55”)
from the TV.
Lift the TV from the pedestal.
Remove the assembly screw from the cover.
Pull out the cover.
Remove the assembly screws from the Bracket.
Remove the assembly screws from the Back of
stand and pull out the neck.
Warning
Do not disassemble or modify the pedestal.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Caution
Do not use any pedestal other than that provided with this TV.
Otherwise, the TV may fall over and become damaged, and personal injury may result.
Do not use the pedestal if it becomes warped or physically damaged.
If you use the pedestal when it is physically damaged, personal injury may result. Contact your nearest Panasonic Dealer immediately.
During set-up, make sure that all screws are securely tightened.
If sufficient care is not taken to ensure screws are properly tightened during assembly, the pedestal will not be strong
enough to support the TV, and it might fall over and become damaged, and personal injury may result.
When removing the pedestal, do not remove the pedestal by any methods other than the specified procedure. (Above)
Otherwise, the TV and/or pedestal may fall over and become damaged, and personal injury may result.