Filter
Top Products
13
Cable Connection
Follow this diagram when connecting your television to a VCR only.
Note: The remote control must be programmed with supplied codes to operate the VCR (see page 56, 57).
VCR Connection
Procedure
1. Select ANT1 in the SET UP menu. (See page 24)
2. Tune the television to the television program you would like to view.
Viewing a television program
Procedure
• Option A
1.
Press the TV/VIDEO button on the remote control to select the video input (VIDEO 1, VIDEO 2, etc.) connected to your VCR.
2. Begin the video.
• Option B
1. Select ANT2 in the SET UP menu.
2. Tune the television to Channel 3 or 4, depending on your VCR.
3. Begin the video.
Viewing a video
Procedure
• Option A (Recording and viewing the same program)
1. Select ANT2 in the SET UP menu.
2. Tune the television to Channel 3 or 4, depending on your VCR.
3. Using the VCR, tune to the television program you would like to record.
4. Begin recording.
• Option B (Recording one program while viewing another program)
1. Select ANT1 in the SET UP menu.
2.
Press the TV/VIDEO button on the remote control to select the video input (VIDEO 1, VIDEO 2, etc.) connected to your VCR.
3. Using the VCR, tune to the television program you would like to record.
4. Begin recording.
5. Press the TV/VIDEO button on the remote control to switch back to TV mode.
6. Tune the television to the program you would like to view.
Recording a television program
PROG OUT
COMPONENT VIDEO INPUT
S VIDEO
DIGITAL
IN
VIDEO
Y
P
B
L
R
L
R
ANT 1 ANT 2
PR
12
12
INPUT
VIDEO
TO AUDIO
AMP
AUDIO
S-VIDEO
VIDEO
ANT INPUT
ANT OUTPUT
AUDIO
R
L
SPLIT
OUT
CONNECTIONS ON BACK OF TV
Incoming Cable
CABLES NOT SUPPLIED
VCR
Use either the S-Video or
the Video connection.
Ferrite core
(large size)
(supplied)
Less than
4” (10cm)