Filter
Top Products
9
Preparation for Wall-hanging
Accessories
Before mounting the display on the wall, you must remove the pedestal from the display.
Follow the steps below:
1
Disconnect all the cables from the display.
2
Remove the pedestal.
A
Remove the four screws.
B
Pull out the pedestal.
Foam mat or thick
soft cloth
WARNING
•
Failure to use a Panasonic bracket or choosing to mount the unit yourself will be done at the risk of the consumer.
Any damage resulting from not having a professional installer mount will void your unit’s warranty.
•
Always be sure to ask a qualified technician to carry out set-up.
Incorrect fitting may cause equipment to fall, resulting in injury and product damage.
•
Do not mount this Plasma display directly below ceiling lights (such as spotlights, floodlights, or halogen lights) which
typically give off high heat. Doing so may warp or damage plastic cabinet parts.
•
Place the display at a comfortable distance for viewing. Avoid placing it where sunlight or other bright light (including
reections)willfallonthescreen.
Useofsometypesofuorescentlightingcanreduceremotecontroltransmitterrange.
Adequate ventilation is essential to prevent an internal component failure. Keep away from areas of excessive heat or
moisture.
■
How to use the pedestal
Adjust the stand to your desired angle.
The stand angle can be rotated 15° to the right / left.
Location
P
O
W
E
R
(View from above)
PDP panel side
15
°
15
°
B
A
A
15
°
15
°