Panasonic TH-42PX600A Flat Panel Television User Manual


 
44
45
FAQs, etc.
Problem Actions
Other
TV takes so long to
turn on
Like your computer, the TV has to run a number of
diagnostic and software checks before it can display any
broadcast channels.
The channel cannot
be changed
Is the TV in Teletext mode? (p. 16)
The channel cannot
be selected
Is the channel locked? (p. 24)
The remote control
does not work
Are the batteries installed correctly? (p. 6)
Has the TV been switched On?
TV goes into
"Standby mode"
The sleep function is activated.
The TV enters "Standby mode" about 30 min. after
broadcasting ends.
An error message
appears
Follow the message's instructions.
If the problem persists, contact the authorized
Service Centre.
FAQs
SD Card: On screen messages
Message Meaning / Action
Cautions in handling SD Card :
Do not remove the card while the TV is accessing data ("blue" LED
On) (this can damage card or TV).
Do not touch the pins on the back of the card.
Do not subject the card to a high pressure or impact.
Insert the card in the correct direction (otherwise, card may be
damaged).
Electrical interference, static electricity, or erroneous operation may
damage the data or card.
Back up the recorded data at regular intervals in case of deteriorated
or damaged data or erratic operation of the TV. (Panasonic is not
liable for any deterioration or damage of recorded data.)
WARNING: As with an small object,
SD card can be swallowed by young
children. Do not allow children to
handle SD card. Please remove SD card
immediately after use.
Is SD Card in?
Insert a SD card.
SD Card is locked
Please unlock to operate
Unlock the SD card.
This le is locked
Please unlock to operate
Unlock the le in the card.
This type of format is not
supported
The TV does not support the format.
(For the applicable formats and data, see p. 40.)
This type of card is not
supported
A card not supported by the TV has been inserted.
(For the supported cards, see p. 40.)
Broken le
Cannot display image
The le is broken.
Memory full
The card memory is full.
Not enough memory
The card does not have enough memory to operate.
Cannot read le
The le is not readable.
Unrecordable source
SD recording is stopped
That channel cannot be recorded. (Recording is automatically
stopped.)
Error
Check card
Re-insert the card. If the error persists, format the card. (p. 31)
Card recording in progress
Please stop recording to operate
That operation is not available during recording.
To continue the operation, stop recording.
(
For example, changing channels while recording a TV
programme.
)
Delete le?
Displayed when you press Red colour button to delete a
MPEG4 le. Press OK button to con rm deleting.
No time data
Cannot store time info
Since the signal does not have the time information, the date is
recorded as 01/01/2000.
SD Card: On screen messages
Frequently Asked Questions
Blue LED