Filter
Top Products
+
-
+
-
Ferrite core
Use the Ferrite cores to comply with
the EMC standard. (see page 20)
Accessories
Requires two AA batteries.
2. Insert batteries - note correct
polarity (+ and -).
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
3. Replace the cover.
Accessories Supplied
Check that you have the Accessories and items shown
Operating
Instruction book
Remote Control Transmitter
N2QAYB000432
Batteries for the
Remote Control
Transmitter
(AA Size × 2)
AC cordClamper × 3
TMME289 J0KG00000146 (Set of 2)
Remote Control Batteries
“AA” size
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
1. Pull and hold the hook, then
open the battery cover.
CD-ROM
(Operating
instructions)
7