Filter
Top Products
Advanced
31
•
Tuning Programmes
Any new services found will be added to the DVB Service List.
Add New DVB Services
RF Ch Service Name Type Quality
Pay TV: - Radio: - Data: -
Searching
Analogue Scan 21 68
Scan 6 69
This will take about 3 minutes.
DVB: 0
•
The new service is added with the current settings
saved as they are.
Add DVB
programme
automatically
Add New
DVB Services
New DVB service found!
Press OK to add new service.
Press EXIT to ignore.
Selects whether to give a notifi cation message when a new DVB service is found. (Off / On)
Display a
notifi cation
message
New Service
Message
Auto Tuning - Digital (DVB)
This will take about 3 minutes.
2
RF Ch Service Name Type Quality
ABC TV Sydney DVB 10
3 SBS DIGITAL 1 DVB 10
4 FTV guide DVB 10
7 7 Digital DTV 10
CH 29 Analogue
-
CH 33
DVB: 3
Searching
Analogue
-
Scan 6 69
EXIT
RETURN
Start Auto Tuning
All digital tuning data will be erased
Auto Tuning
OK
Start Auto Tuning Settings are made automatically
•
All the previous tuning settings are erased.
•
When the operation is completed, the programme at programme position “1” will be
displayed.
•
If tuning has not been done completely “DVB Manual Tuning”, “Analogue Manual Tuning”
Automatically retune all DVB or Analogue programmes received in the area.
•
Only DVB programmes are retuned in DVB mode.
•
Only Analogue programmes are retuned in Analogue mode.
Set all DVB
or Analogue
programmes
automatically
Auto Tuning
DVB Signal Display
Service Name [CH53] 7 7 Digital
Signal Quality
Signal Strength
0
0
10
10
Selects a programme and checks the DVB signal condition.
•
To change the programme
CH
A good Signal Strength is not an indication of
suitable signal for DVB reception. Please use
the Signal Quality indicator as follows:
Signal Quality:
•
Green bar Good
•
Yellow bar Poor
•
Red bar Bad (Check the aerial)
Check
DVB signal
DVB Signal
Display
Set DVB
programme
manually
DVB Manual
Tuning
Normally use “Auto Tuning” or “Add New DVB Services” to add DVB programmes to your
service list.
If tuning has not been done completely or for adjusting the direction of the aerial, use this
function.
select channel
search
DVB Manual Tuning
Physical Channel
Prog. Service Name Type New
DVB: 0
Signal Strength 0 10
Signal Quality 0 10
MHz
474.00[CH21]
•
All services found will be added to the
DVB Service List.
adjust frequency (set where the level of
“Signal Quality” becomes the maximum)
Set Analogue
programme
manually
Analogue
Manual Tuning
1 CH33
Analogue Manual Tuning
Manual Tuning 0 75
Set Analogue programme manually after Auto Tuning.
•
If a VCR is connected only with the RF cable, select programme position “0”.
store
search
Search and storeSelect the programme
CH
Select the programme position
1 32
4 65
7 98
0