Filter
Top Products
7
Connections
●
External equipment and cables shown are not supplied with this TV.
●
Ensure that the unit is disconnected from the mains socket before attaching or disconnecting any leads.
●
Check the type of terminals and cable plugs are correct when connecting.
●
Always use a fully wired HDMI cable.
●
Keep the TV away from electronic equipment (video equipment, etc.) or equipment with an infrared sensor.
Otherwise, distortion of image / sound may occur or operation of other equipment may be interfered.
●
Also read the manual of the equipment being connected.
Terminals
6 7
2
4
3
1
5
1
SD Card slot
2
USB 1 - 3 port
3
HDMI1 - 3 (p. 8, 9)
4
DIGITAL AUDIO OUT
5
AV (COMPONENT / VIDEO)
(p. 9)
6
Aerial terminal
(see below)
7
ETHERNET (p. 8)
Basic connections
Mains lead and aerial
■ Digital TV, Analogue TV
AC 220-240 V
50 / 60 Hz
Mains lead
(supplied)
Aerial
RF cable
■ Mains lead
Make sure that
the mains lead is
securely fixed
To remove from the TV:
tabs
Press both tabs and pull on
mains connector to release
Push until both side
tabs click
●
Keep RF (aerial) cable away from the mains lead to avoid and minimise mains interference pickup.
●
Do not place the RF cable under the TV.
●
An aerial, correct cable (75 Ω coaxial) and correct terminating plug are required to obtain optimum quality picture and
sound.
●
If a communal aerial system is used, you may require the correct connection cable and plug between the wall aerial
socket and the TV.
●
Your local Television Service Centre or dealer may be able to assist you in obtaining the correct aerial system for your
particular area and the accessories required.
●
Any matters regarding aerial installation, upgrading of existing systems or accessories required, and the costs
incurred, are the responsibility of you, the customer.