Filter
Top Products
25
Picture Adjustment
C. TEMP (Colour Temperature)
D.PNR (Digital Picture Noise Reduction)
SCAN MODE
Set the overall colour tone of the picture.
Press to switch between modes.
STANDARD WARM COOL
Automatically reduces undesired picture noise.
Press to switch between modes.
Reduces noise in a channel with many noises.
Remains off when receiving a strong signal.
Off:Recommended mode when receiving a strong signal.
Strong:Applies strong noise reductions regardless of input signals.
Weak:Applies weak noise reductions regardless of input signals.
Auto:Automatically reduces unwanted picture noise.
OFF
STRONG
AUTO
WEAK
100 Hz MODE
PROGRESSIVE
MODE Function
100Hz MODE
100Hz will give a steady picture for most signal transmission.
PROGRESSIVE
Avoids “snaking/jaggy” effect when viewing TV program with
moving characters.
Note:
When viewing a PAL transmission (other than PAL 60) with Scan mode set to Progressive, the screen
will flicker, this is not a fault.
Helpful Hint (
N
Normalization)
By pressing the Normal “N” Button on the Remote Control while the Picture menu is displayed, the selected menu will be changed
to the Normal Mode.
Normalization will not occur if the menu is not displayed when the “N” Button is pressed.
The Normal mode is the factory preset condition. Returning to this original condition is called “Normalization”.
CONTRAST
MENU
PICTURE
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
C. TEMP
DYNAMIC
AUTO
STANDARD
D. PNR
100Hz
SCAN MODE
CONTRAST
MENU
PICTURE
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
DYNAMIC
AUTO
STANDARD
D. PNR
100Hz
SCAN MODE
C. TEMP
CONTRAST
MENU
PICTURE
BRIGHTNESS
COLOUR
SHARPNESS
NTSC-TINT
DYNAMIC
AUTO
STANDARD
D. PNR
100Hz
SCAN MODE
C. TEMP
100Hz
When receiving PAL or
SECAM Signal
When receiving PAL or SECAM Signal, SCAN MODE is
displayed.
Choose the screen refresh method:
Press to switch between modes.