Filter
Top Products
21
Manual Tune
MANUAL TUNE
Press to select the MANUAL TUNE.
Press to access to the MANUAL TUNE.
Search Start.
1
CH 12
29
MANUAL TUNE
PROGRAMME
-
/+
SEARCH
-
/+
RETURN
TV
/
AV
-
EXIT
‘STR’ BUTTON-STORE
Press to select the desired Programme
Number.
Press to select the higher or lower channel.
1
2
Tuning Channels
When a station is found.
SOUND SYS
Press to display the SETUP MENU.
Proceed to the TUNING MENU, and then to the SOUND SYS ( refer to page 26).
2
Press to exit from the Tuning Menu.
This returns the set to the normal viewing condition.
TV/AV
When the desired station is found, press to store.
The tuning position is memorised.
STR
SET UP
Adjust the Sound System ( refer to page 20 step 2 to 3).
3
Helpful Hint
(1) If a clear picture with correct colours cannot be obtained when a Broadcast or AV signal is received, refer to the
“Colour System Selection” operation on page 24.
(2)
(3) When using a VCR without video and audio input/output terminals, it is convenient to connect the aerial cable as
indicated in the instruction manual of VCR and to set the designated channel to programme No. “0”. In that case,
perform manual tune after setting the colour system and sound system in advance. Further, in multi-system VCR,
it is more convenient to set the designated channel to several programme Numbers.
After the Manual tune is finished, under the normal viewing condition press this button to confirm
the tuning condition for each Programme Number. If some Programme Numbers are unused (no
TV stations), it is possible to skip such Programme Numbers. Please refer to the Programme
Number Skip operation on page 23.
SYS SELECT
AUTO TUNE
MANUAL TUNE
FINE TUNE
SKIP
SOUND SYS 5. 5 MHz
COLOUR SYS
AUTO
OFF
ACCESS
AUSTRALIA
TUNING MENU
Before Manual Tune, Regional System must already be set (Refer to page 19).