Filter
Top Products
Fix a M6 screw, through any of the slits in the bracket, into the
corresponding hole in the wall.
Using a level along the top or bottom edge, ensure that holding bracket is
horizontal.
2
Fix the screws through the slits into the remaining three holes.
3
Provisionally tighten the fixing screws.
4
Fixing the insulating spacers to the display
unit
1) Spread a clean cloth over a level floor or base, and place it on the
display unit face down.
2) Remove the screws and covers.
Keep them in a safe place for possible future use.
1
The holding bracket must always be installed. It prevents the display unit from
falling after installation.
If the screws protrude
more than 5 mm, it will
not be possible to
properly install the
display unit.
Carefully place the Wide
Plasma Display face
down on top of a clean
cloth, which has been
spread over a flat
surface with no other
objects on it, and then
proceed to the next
step.
2-4