Filter
Top Products
RJ-11 SIGNAL RJ-45 SIGNAL
1----------------No Connection 1 --------------No Connection
2----------------Ground 2 --------------No Connection
3----------------TIP 3 --------------Ground
4----------------RING 4 --------------TIP
5----------------Ground 5 --------------RING
6----------------No Connection 6 --------------Ground
7 --------------No Connection
8 --------------No Connection
Note: If the distance from the Model 400 to the wall plate is
greater than 12 feet, Patton Electronics recommends that the
jumper cables be of 22, 24 or 26 gauge twisted pair wire, rather
than flat silver cable.
3. Once all wiring is determined to be straight through,
connect the Model 400s to the controller/computer
and the remote peripheral.
D. If your twisted pair cable is terminated to wall jacks,
check to see that the pin connections are straight through
from end to end. If so, connect the Model 400 (pig-tail
version) to the controller/computer and the remote
peripheral.
AT&T standard modular color codes
4
1 - Blue
2 - Yellow
3 - Green
4 - Red
5 - Black
6 - White
1 - Blue
2 - Orange
3 - Black
4 - Red
5 - Green
6 - Yellow
7 - Brown
8 - Slate
3.0 INSTALLATIO
NN
Patton’s Model 400 units are easy to install and should give you
years of trouble-free service. Here are a few simple instructions to
help you get things hooked up right.
A. Since these units work in pairs—you must have one unit
at each end of your twisted pair cable run.
B. If your twisted pair cable is unterminated, follow these
installation steps:
1. Obtain a small flat head screwdriver. Insert the
blade in the slot on the side of the Model 400’s case.
Twist gently to pop the case open.
2. Strip about 1 inch of the outside insulation from the
twisted pair cable. Strip 1/4 inch of insulation from
each wire.
3. Insert the wire ends into the screw terminals and
tighten down the screws in the terminal block onto
the exposed wires.
4. Bring the wire out of the side of the case and snap
the two case halves shut.
5. Connect the Model 400s to the controller/computer
and the remote peripheral.
C. If your twisted pair cable is terminated with RJ-11 or
RJ-45 plugs, follow these steps:
1. If the twisted pair cable is terminated into plugs,
check to see that the pin configuration of the twisted
pair cable is not crossed from end to end. The
cable should be wired straight through.
2. If the Model 400s are being connected to telephone
jacks by way of modular jumper cables, check to see
that the polarity is not reversed as the wires pass
from the Model 400s to the wall plates, and through
the building’s wiring network.
3