Filter
Top Products
4 of 29 ISSUED: 05-09-05 SHEET #: 095-9224-9 12-05-09
3.25"
(83 mm)
A
I
C
WOOD STUD WALL
WALL PLATE
STUD
Installation to Wood Stud Wall
fig. 1.2
fig. 1.1
Using a stud finder, locate and mark the edges of the wood stud used in mounting this product. Use of an "edge
to edge" stud finder is highly recommended. Use a level to draw a vertical line down the center of the stud. Use
wall plate as template to mark center of holes along the vertical line. The top mounting hole should be located
3.25" (83 mm) above the desired screen center as shown in figure 1.1. Drill two 5/32" (4 mm) dia. holes 2.5"
(64 mm) deep. Attach wall arm assembly (A) to wall with two #14 x 2.5" flat head wood screws (C) using #3
phillips screwdrive bit (M) as shown in figure 1.2.
Insert two fastener caps (I) into wall plate mounting holes.
1
CS = CENTER OF SCREEN
WALL PLATE
• Installer must verify that the supporting surface will safely support the combined load of the equipment and all
attached hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder
is highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible to provide hardware for other types of mounting situations (not evaluated by UL).
WARNING