Filter
Top Products
7 of 34
ISSUED: 02-05-09 SHEET #: 202-9272-4 04-12-10
Begin with the shortest length screw, hand thread through multi-washer and tilt bracket into screen as shown
below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
Begin with longer length screw, hand thread through multi-washer, tilt bracket and spacer in that order into screen
as shown below. Screw must make at least three full turns into the mounting hole and fi t snug into place. Do not
over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffl ed
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
For Flat Back Screen
For Bump-out or Recessed Back Screen
SCREEN
MULTI-WASHER
SCREW
TILT BRACKET
(BB or CC)
fi g. 2.2
SPACER
TILT BRACKET
(BB or CC)
SCREEN
fi g. 2.1
MULTI-WASHER
SCREW
2-1
2-2