Filter
Top Products
6 C3649M (7/08)
3. Place the RAM card into the empty slot, and then press down until the clips engage (refer to Figure 5). Do not force the clips to engage
manually as the memory card may not be properly seated.
Figure 5. Inserting the Memory Card
REASSEMBLING THE UNIT
1. Replace the chassis cover using the screws you removed from the sides and rear of the unit (refer to Figure 1 on page 4).
2. Reinstall the unit in a rack enclosure, if necessary, and then reconnect all cables and peripheral equipment you removed earlier.
3. Reconnect the power cord to the unit.
4. If the blue Pelco badge does not illuminate after the power cord is reconnected, turn on the unit by pressing the power button on the
front panel.