Filter
Top Products
To install the wall mount:
1. Attach the monitor bracket to the monitor as shown in Figure 1. Use the M4 x 10 mm screws and split lock washers.
2. Attach the wall bracket to the wall with the short side pointing down. Hardware is not supplied. Use hardware capable of supporting 68 pounds
(30.8 kg). Refer to the following chart for recommended installation surfaces and minimal hardware requirements.
*Recommended strength of concrete is 3600 psi or 25 Mpa.
Figure 1.
Attaching Monitor Bracket
Recommended Mounting Surface Recommended Hardware
Solid Concrete* Four 1/4 x 2 3/4-inch strike anchors
Hollow cinder block Four 1/4 x 2 1/2-inch T-anchors
Wall board/2 x 4’s
Two 1/4 x 2-inch lag bolts (bolts must be attached to
stud) and two 1/4 x 2-inch anchor bolts
Plywood (3/4-inch construction grade) Four 1/4 x 2-inch lag bolts
(4) SCREWS,
M4 X 10 MM
(4) LOCK WASHERS