Filter
Top Products
10 C2652M (1/08)
MOUNTING THE TRANSMITTER/RECEIVER
The FT8332 transmitter/FR8332 receiver can be mounted into a rack (refer to Mounting the Transmitter/Receiver into a Rack) or can be used as a
stand-alone unit. As a stand-alone unit, the transmitter/receiver can be placed on a desktop or can be mounted to a wall (refer to Mounting the
Transmitter/Receiver to a Wall on page 13).
MOUNTING THE TRANSMITTER/RECEIVER INTO A RACK
The FT8332 transmitter/FR8332 receiver can mount into an industry-standard 19-inch (48 cm) equipment rack. The rack must meet the following
requirements:
• EIA-310-D compliant
• Rack column depth: 24 to 30 inches (61 to 76 cm)
• Column-mounting hole provisions: 10-32 UNF-2B threaded holes or square window holes on front columns
• Door systems are acceptable. Front doors must have at least 2 inches (5.1 cm) between the front bezel of the transmitter/receiver and the
inside of the door. Rear doors may only be used on rack columns that are more than 26 inches (66 cm) deep
The transmitter/receiver occupies one rack unit (1.75 inches or 4.5 cm) of vertical rack space.
To install the transmitter/receiver into a rack, do the following:
NOTE: The hardware necessary to mount the transmitter/receiver into a rack is supplied with the unit (refer to Figure 7).
1. Attach one chassis mounting bracket to each side of the unit using three 6-32 x 0.25-inch Phillips flat head screws for each bracket (refer to
Figure 8).
Figure 8. Attaching Chassis Mounting Brackets
WARNINGS:
• Secure the front and rear screws to the support rails.
• Make sure that the FT8332 transmitter/FR8332 receiver is level.
• Slots and openings in the cabinet provide ventilation to prevent the unit from overheating. Do not block those openings. Never place
the unit near or over a radiator or heat register. When placing the unit in a rack, be sure to provide proper ventilation. Allow at least
one rack unit (1.75 inches or 4.44 cm) of spacing between units.
(3) SCREWS
6-32 X 0.25-INCH
PHILLIPS FLAT HEAD
ATTACH
BRACKETS
FT8332/FR8332