Filter
Top Products
C664M-B (8/02) 7
BASIC INSTALLATION
Basic installation covers all the equipment necessary to program and operate the system. Refer to the
Extended Installation
section for PTZ, alarm, sensors, and network connections.
115
230
OR
D
S
P
C
o
l
o
r
C
C
D
C
a
m
e
r
a
DSP Color CCD Camera
1
1
2
2
7
7
Verify that the
voltage is set
correctly for
your location
6
6
3
3
4
4
NTSC
PAL
5
5
Figure 3. Basic Equipment Installation
1 Set the Voltage Selection Switch - Verify that the voltage selection switch is set correctly for your location. This product
is set at the factory to operate on 115 VAC. For 230 VAC operation, move the switch to the 230 VAC position before
applying power to the unit.
2 Connect the power cord to the AC input located on the back panel. Plug the other end of the power cord into an AC outlet.
3 Connect the keyboard to the bottom PS/2 input.
4 Connect the mouse to the top PS/2 input.
5 Set the NTSC/PAL switches to the correct camera setting for your location.
6 Connect the VGA monitor (not supplied).
7 Connect the cameras. Refer to the following table for video coaxial cable requirements:
Video Coaxial Cable Requirements
Cable Type* Maximum Distance
RG59/U 750 ft (229 m)
RG6/U 1,000 ft (305 m)
RG11/U 1,500 ft (457 m)
* Minimum cable requirements:
75 ohms impedance
All-copper center conductor
All-copper braided shield with 95% braid
coverage