Filter
Top Products
C695M-QS (12/03) 5
CONFIGURATION
To configure the DX3100:
ᕡ Press SETUP.
ᕢ Use the camera buttons to enter the four-digit password. The default is 1981. The setup menu
appears.
ᕣ Change the default DX3100 settings:
a. Select RECORDER SETUP on the setup menu and then press ENTER.
b. Change any of the following DX3100 settings:
• IMAGE SIZE: The default is 352 X 240.
• IMAGE RATE: The default is either 8 ips (DX3108) or 16 ips (DX3116).
• TIME/DATE SET: The default is set at the factory.
• DAYLIGHT SAVING: The default is US.
• PTZ PROTOCOL: The default is NONE.
c. Press SETUP to return to the setup menu.
ᕤ Configure the settings for each camera:
a. Select CAMERA SETUP on the setup menu and then press ENTER.
b. Press (down arrow) to select the camera and press ENTER.
c. Change any of the following default camera settings:
NOTE: Select MANUAL to change any setting under RECORD PARAMETER.
• CAMERA NAME: The default name for each channel: CH1 to CH16.
• RECORD TIME: The default is 0 to 24.
• IMAGE QUALITY: The default is 70.
• MOTION SENSITIVITY: The default is 100.
• PTZ RX ADDRESS: The default is 0.
d. Press SETUP to return to the setup menu.
ᕥ Configure the network settings (optional):
a. Select NETWORK SETUP on the setup menu and then press ENTER.
b. Enter the network address information for the DX3100: IP ADDRESS, SUBNET MASK
and GATEWAY.
NOTE: You may also set the network password for this DX3100.
c. Press SETUP to return to the setup menu.
ᕦ Press SETUP to exit the setup menu.
ᕢ
ᕣ
ᕥ
ᕤ