Filter
Top Products
2 PELCO Manual C986M-A (5/95)
Figure 1. RMA14 Dimension Drawing
4.0 SPECIFICATIONS
Dimensions: See Figure 1
Construction: 16-gauge steel
Weight: 8 lbs 12 oz.
5.0 INSTALLATION
The RM14 rack kit is supplied unassembled. The fol-
lowing hardware is provided for use in assembling the
rack kit.
Qty Description
6 10/32 Hex nuts
6 #10 Lock washers
To install the rack kit and monitor, perform the follow-
ing steps:
1. Assemble the rack as shown in Figure 2 using the
supplied hardware.
While assembling, install all hardware loosely un-
til all components are attached and then finish by
tightening all hardware.
2. Set the monitor into the rack, aligning the four (4)
feet with the holes in the base plate.
3. Install rack and monitor as an assembly into con-
sole and make any required electrical connections.
4. Hold into place, aligning mounting holes of the
RMA14 with mounting holes in console, and insert
and tighten required fasteners (not supplied).
A faceplate is supplied if required.