Filter
Top Products
4 C261M-B (1/08)
Description
The EM1450 light duty wall mount has been designed for use with the EH2508, EH2512, EH2515, EH3508,
EH3512, and EH3515 enclosures. It can be installed on any wall or vertical surface and is capable of
supporting up to 20 lbs (9 kg).
The EM1450 has an adjustable tilt table that allows mechanical positioning of the enclosure.
Installation
1. Drill holes in the mounting surface using the mount as a guide.
2. Attach the mount to a solid surface with three 1/4-inch diameter fasteners (not supplied), or where
there are wall studs, use on 5/16-inch fastener and one 1/4-inch fastener.
If you install the mount outdoors, rainwater could leak through the holes of the mounting bolts and
damage the wall.
To prevent water damage, seal the bolt holes with an appropriate sealant. Apply the sealant around
the bolt holes located between the mount and the mounting surface.
3. Attach the enclosure to the tilt table with the two 1/4-20 x 1/2-inch screws (provided).
4. Loosen the cap nut on the tilt table support bracket, adjust the tilt table to the desired direction, and
then retighten the cap nut. Loosen the two screws on the tilt table, adjust the tilt table to the
desired angle, and then retighten the screws.