Filter
Top Products
Gigabit Fiber to Fiber Media Converter Module – Installation Guide
2
Overview
This document contains instructions necessary for the installation
and operation of the Perle Gigabit Fiber to Fiber Media Converter
Module(s) that are used in conjunction with a Perle MCR chassis.
The C-1000MM media converters are unmanaged modules, and
the CM-1000MM are the managed converter modules. These
products allow dissimilar 1000Base-X fiber interfaces to connect to
one another. For information on the management options of the
CM-1000MM module, refer to the MCR-MGT Module User’s
Guide.
These are the fiber to fiber conversion models:
• Multimode to Multimode (MM)
• Multimode to Single Mode (SM)
• Multimode to Single Mode Single Strand (MM)
The first fiber port will be multimode (MM) and the second fiber
port can be either single mode (SM) or multimode (MM) depending
on the model selected. They can operate over different
wavelengths and distances. (See tables below).
Fiber port 1 – MM1
Model Connector Mode Distance
Wavelength
(TX/RX)
All models SC/ST/LC MM. 550 m/1804 ft. 850 nm
Fiber port 2 – MM2/SM2
Model Connector Mode Distance
Wavelength
(TX/RX)
C-1000MM-M2xx05
CM-1000MM-M2xx05
SC/ST/LC MM 550 m/1804 ft. 850 nm
C-1000MM-S2xx10
CM-1000MM-S2xx10
SC/ST/LC SM 10 km/6.2 mi. 1310 nm
C-1000MM-S2xx40
CM-1000MM-S2xx40
SC/ST/LC
SM
40 km/24.9 mi. 1310 nm
C-1000MM-S2xx70
CM-1000MM-S2xx70
SC/ST/LC SM 70 km/43.5 mi. 1550 nm
C-1000MM-S2xx120
CM-1000MM-M2xx05
SC/ST/LC SM 40 km/24.9 mi. 1550 nm