Filter
Top Products
3
Installation
The default switch settings (all switches in the UP position) will
work for most installations. See the Operation section of this guide
for more details.
The converter comes equipped with a bank of DIP switches and
set of jumpers for setting configuration.
The following steps are used to configure the Media Converter.
1. Set the DIP switch settings (optional).
2. Insert the SFP modules (purchased separately) into the
transceiver ports.
3. Connect the power cord strain relief clip (optional) and
connect and apply power.
DIP Switch Settings
The DIP switches are accessible through the opening in the side
of the enclosure.
Link Mode (Switch 1)
Switch Position Mode
Up (default) Smart Link Pass-Through Mode
Down Standard Mode
Smart Link Pass-Through: In this mode, the fiber link state on
one connection is directly reflected through the Media Converter to
the other fiber connection. Since this media converter is protocol
independent, it monitors the Signal Detect indicator from the SFP