Filter
Top Products
6
EN
Preparation for use
This chapter shows you how to prepare your TV-
Video Combi for use.The TV-Video Combi auto-
matically seeks out and stores all available TV
channels.
1.
1.Select the desired language for the on-screen
menu by pressing .
2.
2.Press .
3.
3.Confirm with .
The automatic TV channel search starts.
<14PV 225>
4.
4.
'TIME' and 'DATE' will appear on the TV
screen.
5.
5.Check 'TIME'. If required, please change the
time with the number buttons .
6.
6.Check if the displayed settings for 'DAY',
'MONTH' and 'YEAR' are correct.
7.
7.When all information is correct, save by
pressing .
The preparation for use is now complete.
Decoder allocation
Some TV channels transmit encoded TV signals
which can only be viewed with a commercially
purchased or hired decoder without distur-
bances.You can connect such a decoder to this
TV-Video Combi. The following function will auto-
matically activate the connected decoder for the
desired TV channel.
1.
1.Use
,
or to select the
TV channel which you would like to allocate
the decoder to.
2.
2.Press .The main menu will appear.
3.
3.Use to select 'TUNER
SET UP'. Then press .
4.
4.Use to select 'MANUAL
TUNING'. Then press .
5.
5.Use to select
'DECODER'.
6.
6.Use to select 'ON'
(Decoder switched on).
7.
7.To end, press .
The decoder has now been allocated to this TV
channel.
STATUS/EXIT
FWD 1- B
STOP C-LPLAY B-K
FWD 1- B
STOP C-LPLAY B-K
FWD 1- B
STOP C-LPLAY B-K
MENU
0..9
PROG P–PROG P+
STATUS/EXIT
0..9
PROG P+
MENU
STOP C-LPLAY B-K
3. Installing your TV-Video Combi
PLEASE WAIT
START FINISH
❚❚❚❚❚❚❚❚❚❚❚
❚❚❚❚❚❚❚❚❚❚❚❚
TIME --:--
DATE --/--/--
SMART CLOCK [ON]
END=EXIT
Connecting additional devices
After you have connected additional devices
(satellite receiver, etc.) through the aerial cable,
switch them on. The automatic channel search
will recognise them and save them.
Satellite receiver
If you are connecting a satellite receiver, please
read the section 'Using the satellite receiver'.
Decoder
If you are connecting a decoder, you must
install it as described in the next section.
How can I switch off the decoder?
Use to select 'OFF' (Decoder
switched off).
FWD 1- B
RECHERCHE MANUELLE
SYSTEM [ L ]
PROGRAMME P55
CANAL 055
→DECODEUR [NON]
PROG.PREF. [NON]
SELECT.KL SELECTIONNER B
TERMIN=EXIT
T6411FZ(EN).qx3 03.3.19 16:32 Page 6