Filter
Top Products
Searching for a tape position with
picture (scanning)
1.
1.While a cassette is playing, press
(reverse) or (forward) one or more
times.
2.
2.Press to resume playback.
Still picture
1.
1.During playback, press to stop the
tape and display a still picture.
2.
2.To continue playback, press .
Scanning and still motion interferes with the pic-
ture quality.The sound is switched off.This is not
a fault in your TV-Video Combi.
Searching for tape position without
picture (forward wind and rewind)
1.
1.Stop the tape with .
2.
2.Press (reverse) or
(forward).
3.
3.To stop the tape, press .
Index search
Every time a tape is recorded, an index mark is
written on the tape.
These marked positions can be found again
quickly and easily later.
1.
1.To search for the previous marking, press
and then .
2.
2.For the next marking, press and then
.
3.
3.As soon as the TV-Video Combi finds this marking,
it automatically switches to playback.
Manual Tracking
To adjust the tracking manually, press or
on
the TV-Video Combi during playback
.
Tracking returns to Automatic Tracking Adjustment
when you press or insert a tape.
STOP C-L
P-P+
FWD 1- B
INDEX
REW0- s
INDEX
STOP C-L
FWD 1- BREW0- s
STOP C-L
PLAY B-K
STILL 2
PLAY B-K
FWD 1- B
REW0- s
11
EN
How can I set the counter to '0:00:00'?
You can set the counter to '0:00:00' with .
When you put a cassette in the TV-Video Combi, the
counter will automatically reset to '0:00:00'.
CLEAR
The counter does not move
This occurs when there are no recordings on a por-
tion of a tape.This is not a fault in your TV-Video
Combi.
The screen shows '-0:01:20'
If you rewind a cassette from the tape position
'0:00:00', the counter will show for instance,
'-0:01:20' (the cassette was rewound to 1 minute and
20 seconds before '0:00:00').
'-:--' is displayed in the 'REM' counter
This counter will automatically recognise the length
of the tape. In addition, when you put in a cassette
the TV-Video Combi must first calculate the time
played.Therefore, '-:--' appears first and only after
the tape has been running for a few seconds, the
correct playing time will be shown.
General information
Use 'Manual Recording' to make a spontaneous
recording (for example, a programme currently being
shown).
If you want to start and stop a recording manually, read
the section 'Recording without automatic switch-off'.
If you want to start a recording manually but have it
stopped automatically, read the section
'Recording with automatic switch-off'.(e.g. not to
record to the end of the tape)
Read the section 'Automatic recording from a satel-
lite receiver', if you want a recording to be controlled
automatically by a satellite receiver.
Recording without automatic
switch-off
1.
1.Insert a cassette.
2.
2.Use or to select the
programme number you want to record, for
example, 'P01'.
3.
3.To start recording, press .
4.
4.To stop recording, press .
STOP C-L
REC I
0..9
PROG P–PROG P+
6. Manual recording
T6400EZ-UK(EN).qx3 03.2.20 2:57 PM Page 11