Filter
Top Products
TUNER MODE CONTROL
The Tuner Mode allows you to change the LCD TV’s signal input to Cable or Air
(antenna). It’s important for the LCD TV to know if you want to receive channels from a cable TV signal or an antenna signal.
MAIN CONTROLS
PICTURE
AUDIO
FEATURES
INSTALL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
FACTORY RESET
MANUAL FINE TUNE
INSTALL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
FACTORY RESET
MANUAL FINE TUNE
1
6
2
4
5
ANTENNA
CABLE
AUTO
• When CABLE is selected, channels 2-125 are available.
• When ANTENNA is selected, channels 2-69 are available.
• When AUTO is selected, your LCD TV will search automatically for antenna
or cable channels.
• Immediately after unpacking and plugging in your new television, run the
AUTO
PROGRAM function to set up the TV for the broadcast or cable channels
available in your area. If you do not run the auto program function to set up the
channels, your television may not operate properly.
HELPFUL HINT
Press the MENU button to see the onscreen menu.
Press the CURSOR DOWN button to highlight the INSTALL menu.
Press the CURSOR RIGHT button to enter the INSTALL menu.
Press the CURSOR DOWN button to highlight the TUNER MODE menu,
then press CURSOR RIGHT to confirm.
Press the CURSOR DOWN button to select CABLE, ANTENNA
or AUTO, then press CURSOR RIGHT to confirm.
Press the MENU button repeatedly to clear the menu from the screen.
1
2
3
4
5
6
Your LCD TV can automatically set itself for local area (or cable TV) channels. This makes it easy for you to select only the TV stations in
your area by pressing the CH+ or CH- button.
AUTO PROGRAM (SETTING UP CHANNELS)
Press the MENU button on the remote control to show the
onscreen menu.
Press the CURSOR DOWN button to
highlight the INSTALL menu.
Press the CURSOR RIGHT button
to enter the INSTALL menu.
Press the CURSOR DOWN button to
highlight the AUTO PROGRAM control.
Press the CURSOR RIGHT button to start the AUTO PROGRAM scanning
of channels.
Press the MENU button repeatedly to clear the menu from the screen, after
AUTO STORE has finished.
1
2
3
4
5
6
AUTO STORE
PLEASE WAIT
PROG.FOUND 0
CHANNEL 3
INSTALL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
FACTORY RESET
INSTALL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
FACTORY RESET
START?
MANUAL FINE TUNE
MANUAL FINE TUNE
MAIN CONTROLS
PICTURE
AUDIO
FEATURES
INSTALL
LANGUAGE
TUNER MODE
AUTO PROGRAM
CHANNEL EDIT
FACTORY RESET
MANUAL FINE TUNE
ANTENNA
CABLE
AUTO
• Immediately after unpacking and plugging in your new television, run the auto
program function to set up the TV for the broadcast or cable channels available in
your area. If you do not run the auto program function to set up the channels ,
your television may not operate properly.
• After you’ve run Auto Program, check out the results. Press the CURSOR DOWN
or the CURSOR UP button and see which channels you can select.
• Remember, an antenna or cable TV signal must first be connected to your LCD TV.
HELPFUL HINT
5