Filter
Top Products
English
11
Connectingtheantennaorthecable
Be sure your antenna or other device is connected properly before
plugging in the AC power cord.
IfyouconnecttoanantennathroughRFcable
Any DTV programs that are broadcasted in your area can be received
for free through an antenna connection.
ININ
OUT
antenna
RFcable
cable
Ifyouconnectaset-topboxthroughRFcable
If the TV is connected to a cable box or satellite set-top box via a
coaxial connection, set the TV to channel 3, 4 or the channel specied
by the service provider.
IN
ININ
OUT
set-topbox
RFcable
antenna
RFcable
Ifyouconnectaset-topboxthroughHDMI
If the TV is connected to a cable box or satellite set-top box via HDMI,
make sure you select the correct Source by using SOURCE.
IN
ININ OUT
set-topbox
HDMIcable
RFcable
TheseHDMIInputsare
availableon26inchand
largerscreensizeTVs.
Ifyouconnectaset-topboxthroughComponentVideoInput
If the TV is connected to a cable box or satellite set-top box via
Component Video Input, make sure you select the correct Component
Video Source by using SOURCE.
IN
OUTOUT
IN
IN
IN
IN
OUT
OUT
set-topbox
RFcable
Audio(L/R)cables
Component(Y/Pb/Pr)videocables
Connectingaset-topbox,Blu-raydisc/DVDrecorder
viacompositeconnectorsandAnalogAudio
Do not place your recorder too close to the screen because some
recorders can be susceptible to signals.
ININ
OUT
OUT
OUT
OUT
OUT
IN
IN
IN
OUT
IN
RFcable
RFcable
cable
set-topbox
Blu-raydisc/DVDrecorder
Audio(L/R)+Videocables
Audio(L/R)+
Videocables
Note
• If you have any question about the DTV’s antenna, visit www.antennaweb.org for further
information.
• Depending on your antenna system, you may need different types of combiners
(mixers) or separators (splitters) for HDTV signal. The minimum RF bandpass on these
devices is 2,000MHz or 2GHz.
• For your safety and to avoid damage to this unit, please unplug the RF coaxial cable
from the antenna Input jack before moving the unit.
• If you did use an antenna to receive Analog TV, it should also work for DTV reception.
Outdoor or attic antennas will be more effective than a set-top box or inside antenna.
• To Turn On your reception source easily between antenna and cable, install an antenna
selector.
• If you are not receiving a signal from your cable service, contact the Cable provider.
• Only the left loudspeaker reproduces sound for mono equipment. Use a mono to
stereo adapter (not supplied) for sound reproduction via all internal loudspeakers.
PluggingintheACpowercord
Make sure that the AC power cord must be plugged to an AC outlet
after all the necessary connections are made.
Caution
• Do not connect the AC power cord to a power supply outside the indicated voltage of
this unit (AC 120V).
• Connecting the AC power cord to a power supply outside of this range may result in
re or electrical shocks.
Note
• Each time you plug in the AC power cord, no operations will be performed for a few
seconds. This is not a malfunction.