Filter
Top Products
6
CABLE BOX (WITH RF IN / OUTPUTS):
CABLE BOX (WITH AUDIO / VIDEO OUTPUTS):
CABLE
IN
TO
TV
3 4
OUTPUT
CH
Cable Box
The Cable TV
singal from
Cable Company
75Ω coaxial cable
1
2
5
3
Walloutlet
4
CABLE
IN
TO
TV
VIDEO
OUT
SVIDEO
L
R
AUDIO
OUT
3 4
OUTPUT
CH
Cable Box
Cable TV singal
1
2
Walloutlet
3
Connect the Cable TV signal to the IN jack (or RF IN or CABLE
IN) on the Cable Box.
Connect an RF coaxial cable (not supplied) to the OUT jack (or
TO TV or RF OUT) of the Cable Box.
Connect the other end of the coaxial cable to one end of the
supplied L-Adapter as shown, and connect the other end of the
adapter to the TV jack on the LCD TV.
Plug the power cable into AC inlet on LCD TV set. Plug the
power cable into an outlet and switch TV set on.
Set the Channel 3/4 (or Output channel) switch of the Cable Box
to 3 or 4. Set the TV to the same channel. When watching TV
programming, change channels at the Cable Box, not the LCD TV.
1
2
3
4
5
•
Immediately after unpacking and plugging in your new television,
run the auto program function to set up the TV for the broadcast
or cable channels available in your area. If you do not run the auto
program function to set up the channels , your television may not
operate properly.
•
Please make sure that you have selected the TV mode with AV key
on your remote control, before installing TV channels.
HELPFUL H
INT
HELPFUL HINTHELPFUL H
This connection will supply stereo sound to the LCD TV.
Connect the Cable TV signal to the IN jack (or RF IN or CABLE
IN) on the Cable Box.
Using an RCA-type video cable (not supplied) connect one end of
the video cable to the Video Out jack of the Cable Box. Connect
the other end of the cable to the yellow VIDEO jack on the side
of the TV. Video cables are usually marked with yellow and are
available from Philips or electronics retailers. Video jacks on most
equipment are yellow.
Using RCA-type, stereo audio cables (not supplied), connect one
end of the cables to the left and right Audio Out jacks of the Cable
Box. Connect the other end of that cable to the Audio jack on the
side of the LCD TV. Audio cables are usually marked with red and
white and are available from Philips or electronics retailers. The
right audio jack is red and the left audio jack is white. Match the
cable colors to the jack colors.
Plug the power cable into AC inlet on LCD TV set. Plug the power
cable into an outlet and switch TV set on.
1
2
3
Note: Use the AV button on the remote control to tune to the AV channel
for the cable box signal. Once tuned, change channels at the cable box, not
the television.
When you watch programs using VCR, it’s recommended to select Soft
Mode via Smart picture.
4