Filter
Top Products
6
2. Setting up the monito
r
Connecting to your PC
4
4
5
1
AC s input
2
VGA input
3
HDMI inputs (HDMI1 and HDMI2)
4
HDMI audio output
5
Kensington anti-theft lock
Connect to PC
1. Connect the power cord to the back of
the monitor firmly.
2. Turn off your computer and unplug its
power cable.
3. Connect the monitor signal cable to the
video connector on the back of your
computer.
4. Plug the power cord of your computer and
your monitor into a nearby outlet.
5. Turn on your computer and monitor. If the
monitor displays an image, installation is
complete.
Connecting your 3D Glasses Kit to
273G3D monitor
How to use your wireless 3D glasses:
IR Receiver
LED Indicator
Micro USB Port (charging)
Power Switch
1. Power on: Press “Power Switch”. The red
“LED Indicator” will be on for 2 seconds.
2. Power off: Press “Power Switch” to turn off
the glasses.
Note
1. Ensure there is direct line-of-sight between
emitter and 3D glasses. The minimum
recommended gap is 45cm.
Any obstructions may result in failure to
receive the signals from Emitter.
If “IR Receiver” does not receive signals from
emitter, the 3D glasses will enter standby
mode automatically after 5 seconds, and the
power will be completely turned off after 1
minute of signal disconnection.
2. The 3D glasses are designed for 3D viewing
only. It is required to turn on the power
switch again for 3D viewing after finishing
2D mode.