Filter
Top Products
Ò Press π to enter the channel list.
† Press o or œ in the channel list to select the
channel you want to uninstall or reinstall.
º Press the green key to uninstall or reinstall the
channel.
◊Press Menu to quit the menu.
6.3.3 Reorder the channels
Change the order of the stored channels.
‡ Press Menu.
® Select Setup > Installation > Channel
installation > Rearrange.
Ò Press π to enter the channel list.
† Press o or œ in the channel list to select the
channel you want to reorder.
º Press the yellow key to move up the highlighted
channel in your channel list.
◊Press the blue key to move down the
highlighted channel in your channel list.
‹Press Menu to quit the menu.
6.4 Channel management
6.4.1 Automatic search
Once a day, early in the morning, the TV searches
for all available TV channels automatically. Leave
your TV in standby.
Earlier found channels are updated and new
channels are stored. Channels not found by the
search anymore are removed from the channel list.
When Channel management has found or removed
channels, a message at TV start up is shown.You
can activate or deactivate this message.
‡ Press Menu.
® Select Setup > Installation > Channel
installation > Startup message.
Ò Select On or Off.
6.4.2 Manual search
You can install the updates at any time.
‡ Press Menu.
® Select Setup > Installation > Channel
installation > Installation update.
Ò Press π to enter the Installation update menu.
† Press
OK.
º Press the green key to start.
The update starts and may take a few minutes.
◊When the update is completed, press the red
key to return to the Channel installation menu.
‹Press Menu to quit the menu.
6.5 Digital reception test
If you receive Digital TV broadcasting you can verify
the quality and signal strength of a specific channel.
‡ Select a channel.
® Press Menu.
Ò Select Setup > Installation > Channel
installation > Digital:Test reception.
† Press π to enter
º Press
OK.
◊Press the green key to start the test.
Information on the quality and the signal
strength of this channel is shown.
‹Use the cursor keys to change the frequency to
improve the signal or enter a new frequency
directly with the digit keys.
≈Press the green key to store the frequency if
the signal quality and strength are good.
ÚPress the red key to return to the Channel
installation menu.
œ Press Menu to quit the menu.
à Tip
To achieve the best results, contact a specialised
antenna installer.
6.6 Factory settings
You can want to return to the original factory
settings. Only picture and sound settings are reset.
‡ Press Menu.
® Select Setup > Installation > Factory settings.
Ò Press π to enter the Factory settings menu.
† Press
OK.
º Press Menu to quit the menu.
28 Channel installation
2713.2 EN 01-07-2008 13:24 Pagina 28