Philips 42-3D6C01/00 Flat Panel Television User Manual


 
Display User Manual
3D Solutions
23 September 2008
©2008 Philips Electronics Nederland B.V. 13 of 26
3.4 Mounting
The display can be placed on a table stand or wall-mounted. The table stand is supplied as standard;
the mounting bracket can be purchased separately. This bracket can also be used as an adapter in
combination with universal wall supports, ceiling supports or universal floor stands (e.g. Vogel’s
Professional).
3.4.1 Fitting the table stand
Only use the stand supplied with the set, making sure that the fasteners are properly tightened. Never
use a makeshift stand, or legs fixed using woods crews.
3.4.2 Using the mounting bracket
The standard VESA mount holes on the mounting bracket allow the user to install the Philips 3D
display on any VESA MIS-E compatible wall support, ceiling support or floor stand.
Important: Use a VESA MIS-E compatible support suitable for the weight of this 3D Display.
Always secure the mounting bracket to the display using 4 screws. This helps avoid potentially
dangerous situations when lifting the display out of the mounting bracket.
3.5 Positioning the display
For the best results, choose a place where there is no direct light shining onto the screen, and which is
some distance away from radiators or other sources of heat. Leave a space of at least 10 cm all around
the display for ventilation, making sure that curtains, cupboards etc. cannot obstruct the airflow
through the ventilation apertures. The display is intended for use in a public places only and should
never be operated or stored in excessively hot or humid conditions.