Filter
Top Products
12
TV menu-Installation
Select Autoprogram in the Installation menu.
Use the cursor right to enter the Autoprogram menu.
Select Cable or Antenna in the Installation mode.
When Antenna is selected, the TV will detect antenna
signals and will search for antenna TV (NTSC and ATSC) channels
available in your local area.
When Cable is selected, the TV will detect cable company
supplied signals and will search for cable TV (NTSC, ATSC, QAM
modulated) channels available in your area.
Make sure that registration with your cable TV provider and
connection of equipment are completed.
Select Start now with the cursor right key.
Press the OK button.
Press the green button “Start” to start Autoprogramming. The
menu screen disappears and the progress of Autoprogramming
is displayed. The progress bar indicates the number of analog and
digital TV channels found.
Auto programming may take up to 20 minutes to complete. Digital
channels will take longer than Analog to fi nd and program. Please
wait until you see the Auto Programming complete message. The
TV will then switch automatically to the fi rst channel found.
Note: All channels must be unlocked in order to autoprogram. If
requested, enter your PIN code to unlock all channels. (p. 25)
Info
Installation Language7 3
Français
Español
English
Language
Autoprogram
Source
Clock
Weak channel installation
Current software info
Reset AV settings
Info
Installation Autoprogram7 2
Cable
Antenna
Language
Autoprogram
Source
Clock
Weak channel installation
Current software info
Reset AV settings
Television Installation
You can now start automatic installation. This
procedure can take more than half an hour.
Previous Start
Info
Autoprogram 2
Weak channel installation
Current software info
Antenna
Antenna
Cable
Start now
Notes:
• When you have locked TV channels before initiating Autoprogram, a message appears asking to enter your PIN code in
order to complete Autoprogramming.
• ATSC channel information is updated automatically when the TV is in standby after 3 minutes and every 3 hours thereafter.
• When channel update is interrupted, the new updated channel information is retained along with the old un-updated
channel information.
• Channel information about an ATSC channel is updated only for the ATSC channel currently tuned.
• If an NTSC channel is tuned, then in Background Autoprogramming the TV will scan all the possible ATSC frequencies
and update information.
• Weak channel installation allows you to manually tune weak ATSC channels in order to adjust the antenna and thus
optimize signal quality for that channel. (See Installation menu, Weak channel installation, p. 13.)
• Once you have searched for the available Antenna as well as the Cable TV channels, they are stored in the memory.
• If Antenna/cable signal is interrupted more than ten minutes, TV will go into off mode. You are requested to press Power button
or
CH + / - button to turn on the TV.
Select the menu language
Press the MENU button on the remote control.
Use the cursor down to select Installation in the Settings menu.
Use the cursor right to enter the Installation menu.
Select Language and enter the list of available languages with the
cursor right.
Select your preferred language with the cursor up/down and press
the OK button to confi rm your selection.
Proceed with the Installation menu.
Store TV channels
1
2
3
4
5
6
1
2
3
4
5
6